Data Realms Fan Forums
http://forums.datarealms.com/

Need help setting offsets ._.'
http://forums.datarealms.com/viewtopic.php?f=1&t=45918
Page 1 of 1

Author:  NikolaAnicic007 [ Fri Mar 13, 2015 11:42 am ]
Post subject:  Need help setting offsets ._.'

Hello, I have a problem with setting offsets, I know how to determine them and everything but they always seem to be out of place, even when I check the tutorial every five seconds .____.'

I could use some help setting the offsets for some of my guns (pistols, snipers, AR's, etc.)

Help would be much appreciated!

P.S If you have any suggestion for further code change, I will gladly look into it!

Author:  Arcalane [ Fri Mar 13, 2015 2:52 pm ]
Post subject:  Re: Need help setting offsets ._.'

How far out of place? Remember, SpriteOffset values are always a) negative, and b) absolute. Next, keep in mind that everything else is relative. From there, make sure you're not forgetting to use a minus sign when you should be or using one when you shouldn't be - it's an easy mistake to make. Finally, if it's a hand (joint/support offsets) try adjusting them back one and down one.

If you want any more help than that you're probably going to have to provide an example of a weapon and the offsets you've determined, so we can actually see exactly where you're going wrong. :???:

Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/